IMPORTANT NOTICE !! Read the enclosed instructions carefully before attempting to install this door. Pay close attention to all warnings and importa
10 STEP 12 INSTALLING THE OPTIONAL TENSION-PRO SPRING ADJUSTMENT BRACKET STEP #12a: Install the Tension-Pro™ brac
11 To Increase Spring Tension: Move the door to the fully open position and place clamps on the guides to prevent door from closi
12 Roll-Up Sheet Door LIMITED WARRANTY Wayne-Dalton P.O. Box 67- Mt. Hope, Ohio 44660 The Manufacturer warrants the ROLL-UP SHEET DOOR and h
13 Limited Warranty for Paint on the following Wayne-Dalton products Roll-Up Doors Model Nos. • DS 50, • DS 75, • DS 100, • DS 200, • DS 350 Inte
14 This limited warranty applies to the effects of weathering and does not apply to other causes of degradation, such as in the case of (by way of
15F. Other Terms. This limited warranty is made to the Original Owner, exclusively, and not to anyone who or which subsequently owns or possesses
2 CAUTION CAUTION WARNING IMPORTANT! HINT: NOTE: IMPORTANT SAFETY NOTICES Read the enclosed instructions carefully before attempting installation.
3INTRODUCTION This manual's main function is to assist the installer in correctly installing the doors to ensure safe operation. Compliance wit
4 STEP 1 UNPACKING DOORS Before removing the door from any packaging, inspect the packaging for visible signs of damage. If damage is noted, file a
5STEP 3 INSTALLING GUIDES Position the left hand guide 3/8” from the edge of the left hand jamb and loosely clamp in place. Using a level, adjust
6 HINT: STEP 5 LIFTING THE CURTAIN ASSEMBLY Curtain assembly is heavy. Allowing curtain assembly to fall while lifting, could result in severe or
7STEP 7 PRE-TENSIONING THE DOOR SPRING Spring tension can cause curtain assembly to rotate rapidly, possibly resulting in severe or fatal injury.
8 STEP 9 CHECKING AND ADJUSTING SPRING BALANCE Spring tension can cause curtain assembly to rotate rapidly, possibly resulting in severe or fatal
9II: DS-50 & 100 ‘C’ Stop-Clip Attachment: For doors with an aluminum bottom bar, a ‘C’ stop-clip will need to be installed. Only one bolt is r
Comments to this Manuals