Wayne-Dalton Optimal Owner's Manual download pdf (Page 17)

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com

Attaching Disconnect Handle

#6-20 x 1/2”

Screw

Disconnect

Handle

Bracket

Disconnect

Cable

Disconnect

Handle

Upper

Position

Apply Emergency Disconnect Label next to

the mounted bracket. Use mechanical

fasteners if adhesive will not adhere.

Using the Emergency Disconnect, pull

Disconnect Handle downwards and place it

in the manual door operated position (Use

Disconnect Label for reference). Motor will

be rotated 90° from its packaged position.

If Motor does not pivot 90°, see

troubleshooting section in this manual.

Disconnect Handle Usage

Emergency

Disconnect

Label

Manual operated position Motor operated position

Tools Needed:

None

Tools Needed:

Phillips

Head Screwdriver

Wire Cutters

Flat Blade

Screwdriver

NOTE: The motor must be in the fully down

position before setting handle position on

cable. Bring Motor to the down position by

pulling the disconnect cable while pushing

the motor down. Insure Opener disconnect

teeth are engaged before installing

Disconnect Handle. If motor is not fully

down when teeth are engaged, turn motor

shaft with screwdriver at back of motor

counter clockwise until motor is fully down.

Start the #6-20 x 1/2" Screw into the

Disconnect Handle. Thread the Disconnect

Cable through the top of the Disconnect

Handle Bracket and then the Disconnect

Handle.

Locate the Disconnect Handle in full upper

position of Disconnect Handle Bracket.

Remove all Disconnect Cable slack

between the Opener and the top of the

Disconnect Handle Bracket. Tighten #6-20

x 1/2" Screw into the Disconnect Handle

until snug, and then tighten Screw an

additional 1 to 1-1/2 turns to secure

Disconnect Cable to the Disconnect Handle.

Trim off excess cable from bottom of the

Disconnect Handle.

CAUTION: PULL CABLE ONLY TAUT

ENOUGH TO REMOVE THE CABLE SLACK.

PULLING THE CABLE MORE COULD CAUSE

OPENER TO DISCONNECT FROM THE

TORQUE TUBE AND CAUSE FAILURE OF

THE DISCONNECT.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 45 46

Comments to this Manuals

No comments

Wayne-Dalton Optimal Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Garage Door Opener Wayne-Dalton Optimal