Wayne-dalton 9800 User Manual download pdf (Page 21)

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com

Attaching Horizontal Track to

Adjustable Flagangle

NOTE: If quick install ﬂagangles were

installed in Step 13, skip this step and

continue with Step 15. If not, complete

this step.

To install horizontal track, place the

curved end over the top roller. Align

the bottom of the horizontal track with

the vertical track. Hand tighten the

horizontal track to the ﬂagangle with

(1) stud plate and (2) 1/4” - 20 ﬂange

hex nuts.

DO NOT RAISE DOOR UNTIL

HORIZONTAL TRACKS ARE SE CURED

AT REAR, AS OUTLINED IN STEP 33, OR

DOOR COULD FALL FROM OVERHEAD

POSI TION CAUSING SEVERE OR FATAL

INJURY.

Level the horizontal track assembly and

bolt the horizontal angle to the slot in

the ﬂagangle using (1) 3/8” - 16 x 3/4”

truss head bolt and (1) 3/8” - 16 hex

nut. Repeat for other side. Remove the

nail that was temporarily holding the

top section in place, installed in Step

12.

IMPORTANT: FAILURE TO REMOVE NAIL

BEFORE ATTEMPTING TO RAISE DOOR

COULD CAUSE PERMANENT DAMAGE

TO TOP SECTION.

NOTE: If an idrive

opener will be

installed, position horizontal tracks

slightly above level.

9/16” Socket

7/16” Socket

Ratchet Wrench

9/16” Wrench

Level

Flat tip

Screwdriver

WARNING

1/4”-20 FLANGE

HEX NUTS

FLAGANGLE

3/8” - 16 X 3/4”

TRUSS HEAD BOLT

3/8” - 16 HEX NUT

HORIZONTAL

TRACK

HORIZONTAL ANGLE

FLAGANGLE

INSTALLATION

STUD

PLATE

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Comments to this Manuals

No comments

Wayne-dalton 9800 User Manual Page 21

Comments to this Manuals

Related products and manuals for Furniture Wayne-dalton 9800