Wayne-dalton 9800 User Manual download pdf (Page 27)

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com

Rear Support

KEEP HORIZONTAL TRACK

PARALLEL AND WITHIN 3/4”

MAXIMUM OF DOOR EDGE,

OTHERWISE DOOR COULD FALL,

RESULTING IN SEVERE INJURY OR

DEATH.

Raise the door until the top section

and half of the next section are in a

horizontal position. Do not raise door

any further since rear of horizontal track

is not yet supported.

RAISING DOOR FURTHER CAN

RESULT IN DOOR FALLING AND

CAUSE SEVERE INJURY OR

DEATH.

Clamp a pair of vice clamps on the

vertical tracks just above the second

roller on one side, just below the second

roller on the other side. This will prevent

the door from raising or lowering while

installing the rear support.

Using perforated angle, 5/16” x

1-5/8”hex head lag screws and 5/16”

bolts with nuts (may not be supplied),

fabricate rear support for horizontal

tracks. Attach horizontal tracks to

the rear supports with 5/16”-18 x

1-1/4” hex bolts and nuts (may not be

supplied). Horizontal tracks must be

level and parallel with door.

NOTE: If rear supports are to be

installed over drywall, use 5/16” x 2”

hex head lag screws.

Adjust weather seal or door stop (if

necessary) Now permanently attach

the weather seal or door stop to both

door jambs and header. (Temporarily

attached in PREPARING THE OPENING

on page 10.) Avoid pushing weather

seal or door stop too tightly against face

of door.

WARNING

Ratchet Wrench

1/2” Socket

1/2” Wrench

Vice Clamps

DOOR IN THE

UP POSITION

VERTICAL

TRACK

3/4”

VICE

CLAMPS

DOOR EDGE

HORIZONTAL TRACK

INSTALLATION

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments

Wayne-dalton 9800 User Manual Page 27

Comments to this Manuals

Related products and manuals for Furniture Wayne-dalton 9800