Wayne-Dalton Optimal Owner's Manual download pdf (Page 21)

Tools Needed:

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com

Mounting Wall Station

(Continued)

Remove the Battery Cover (right-hand side

of Wall Station) by disengaging the Battery

Cover’s lower clip.

Install two AAA Batteries into the Wall

Station observing the polarity, (+) and (-),

of both batteries. After about three seconds,

the Up/Down red LED will begin to blink

momentarily every 1 second.

Re-install the Battery Cover by first inserting

its top into the Wall Station then inserting

and securing its bottom.

Apply Entrapment Label in a convenient

location next to the Wall Station. Use

mechanical fasteners if adhesive will not

adhere.

NOTE: To slow blink rate or turn off, refer to

wall station operation page 28 “Backlit LED

Lights”.

Installing Battery

Lower Screw Installation Upper Screw Installation

Battery

Cover

Up/Down

LED

Entrapment

Label

If mounting to a NEMA electrical device box,

use machine thread screws provided in place

of the wood screws. No drilling is required. If

high voltage wiring is contained in the box,

a standard NEMA solid faceplate must be

installed between the box and the Wall

Station. If fastening into drywall or concrete,

use anchors provided. When mounting to

wood use a 3/32" drill bit and the Drilling

Template located on page 38.

Drill the two 3/32” mounting holes using the

drill template. Drill 3/16" holes if using

anchors.

Install lower screw leaving 3/16" of the

screw exposed. Slide Wall Station Keyhole

Slot onto the lower Phillips Head Screw. Wall

Station should slide onto screw, providing a

snug fit. If necessary remove Wall Station and

loosen or tighten lower Phillips Head Screw

until a snug fit is achieved.

Once Wall Station is fitted on lower screw,

install upper screw. Do not over-tighten.

CAUTION: Over-tightening the upper screw

could deform plastic case.

3/16”

Keyhole

Slot

Phillips

Head Screw

Phillips

Head Screw

Wall

Station

(2) AAA

Batteries

Lower

Clip

Tools Needed:

Power Drill

3/16” or

3/32" Drill Bit

Phillips Head

Screwdriver

Tools Needed:

None

PRE-OPERATION INSTALLATION

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Comments to this Manuals

No comments

Wayne-Dalton Optimal Owner's Manual Page 21

Comments to this Manuals

Related products and manuals for Garage Door Opener Wayne-Dalton Optimal