Wayne-Dalton Optimal Owner's Manual download pdf (Page 25)

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com

Tools Needed:

Flat Tip

Screwdriver

Pliers/Wire

Cutters

Needle Nose

Pliers

a. Uncoil Wires from Safety Sensors and

route Wires up garage wall and above

Torque Tube towards the right side of the

Opener.

Route Wires behind Torque Tube and

tack Wires in place with Insulated

Staples.

NOTE: If Wires must be lengthened or

spliced use wire nuts or suitable

connectors.

NOTE: Take care to run Wires in a

location where they will not interfere

with the operation of the door and do

not staple through Wire.

b. Using a pair of Needle Nose Pliers,

gently pull Terminal Block from right

hand side of Opener. Separate Wire ends

and strip about 1/2” of the insulation off

each of the Wire ends.

c. Using the Flat Tip Screwdriver to loosen

the screw above Hole #1 of the Terminal

Block. Insert both Sender and Receiver

Solid White Wires into Hole #1. Tighten

the screw above Hole #1 till both sender

and Receiver Solid White Wires are

secured tightly. Insert both Sender and

Receiver wires (white with black stripe)

into Hole #2 by the same process.

Note: One Wire has a black stripe. Be sure

to observe polarity. Apply tension to external

Wires to test for secure connection. Check

that the Wires are stapled in place and

staples have not cut Wire insulation.

d. After Wires are secured in Terminal

Block, snap Terminal Block back in right

hand side of Opener.

e. Keep the Safety Sensor Wires straight

and organized by coiling them up around

on the backside of the Opener.

f. Once Terminal Block has been snapped

in, install Jumper from hardware bag on

pins labeled. “P.E.”, located on the front

of the Opener.

IMPORTANT! Keep Sender/Receiver Wires

away from moving parts.

Sensor Wire Installation

(Only When Required)

Terminal

Block

Connector

Hole #2

White with Black

Stripe Wires

Hole #1

Solid White

Wires

Insert with

Screws

Facing Down

Safety

Sensor Wires

Jumper

Wire Routing

Flat Tip

Screwdriver

Needle Nose

Pliers

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 45 46

Comments to this Manuals

No comments

Wayne-Dalton Optimal Owner's Manual Page 25

Comments to this Manuals

Related products and manuals for Garage Door Opener Wayne-Dalton Optimal